Dedicated to Bringing about the Greening of the World, One Vision at a Time
Electromagnetic Reciprocating Engine


The MANGETIC RENEWABLE SYSTEM is the solution. It similar to the Combustion Engine but it’s powered by electricity. It will replace all Combustion Engines in transportation and electricity generation.


The MANGETIC RENEWABLE SYSTEM is the combining of two systems, the Electromagnetic Reciprocating Engine and an Electrical Power System. The Electromagnetic Reciprocating Engine converts electricity to Magnetic Energy to Kinetic Energy to turn a crankshaft. The Electrical Power System can be a battery, or an alternator, or a generator. These two systems working together will produce a renewable power source for transportation and electricity generation.


The MANGETIC RENEWABLE SYSTEM is an energy converter, it does not create energy. It takes electricity from a battery, converts it to Magnetic Energy using electromagnets, and converts that Kinetic Energy to Mechanical Energy using the crankshaft. The electricity, stored in a battery, is the primary energy source.


The MANGETIC RENEWABLE SYSTEM are three primary systems working together.


  • Magnetic Chamber - converts electricity to motion
  • Crankshaft - turning a haft stroke
  • Power Source - electricity


Magnetic Chamber


The Magnetic Chamber uses the physics of magnetism, opposite poles attract (pull) and same poles repel (push). The Magnetic Chamber uses an electromagnet powered by electricity to change the poles and the amount of magnetic forces. The electromagnet is in the center of two permanent magnets. The permanent magnets move in a linear motion (up and down). This is the Magnetic Chamber, connecting multiple Magnetic Chambers together can produce various horsepower and torque.


The Magnetic Chamber is connected to the crankshaft, turning the crankshaft a ½ stroke.


Haft Stroke Crankshaft


The crankshaft is the best way to convert energy into torque (work) for the least amount of energy. Every turn of a crankshaft is a stroke, when energy (power) is applied to a stroke it is called the power stroke. The number of strokes it takes to produce a power strokes depends on the type of fuel. The combustion engine uses 4 strokes because of the combustion process, burning fossil fuels.


The problem with 4 strokes is that 3 strokes are not producing power. This requires the power stroke to have enough energy to turn the dead strokes.


The Electromagnetic Reciprocating Engine uses a ½ stroke. Power is applied every haft turn, using a small amount of energy compared to the 4 strokes.


The crankshaft is an energy converter that uses mechanical advantage. Mechanical Advantage is used to convert one type of energy into mechanical energy with the objective of increasing the amount of energy. The ½ stroke has two benefits over the 4 strokes because of mechanical advantage.




Power Sources


The Electromagnetic Reciprocating Engine is powered by electricity. The electricity is primarily for the electromagnet. There are three sources of electricity, each source has advantage.


Electricity Source

  • Batter Bank – Storage – limited supply, maximum horsepower output
  • Alternator – Renewable – unlimited supply, powers the engine only
  • Generator – Renewable – unlimited supply, large electricity output



© 2018 SEKOU LLC